Octopus 3-Axis GYRO Sensor

Octopus Electronic Bricks, you can use them build electronics projects just as easy as piling bricks. By using Octopus electronic bricks, you may connect Arduino/Freaduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos…even buttons, just plug and play.

3-Axis GYRO Sensor is a sensor module based on the IC ITG3205 axis gyro . ITG3205 is a digital output MEMS gyroscope (also called angular velocity sensor), with three 16-bit analog - digital converter (ADC), digital gyroscope output. Users can select the internal low-pass filter bandwidth, and high-speed I2C serial Interface (400KHZ) Additional features include a built-in temperature sensor and a 2% accurate internal oscillator.

Features:

• the digital output X, Y, Z-axis angular value velocity sensor in a single circuit, with the least significant 16 bits (LSBs) ° / sec sensitivity and ± 2000 ° / sec full scale range.
• the programmable digital low-pass filter
• less than 6.5mA operating current, greatly extending battery life, standby current of only 5uA
• VDD power supply range 2.1V-3.6V
• the digital output temperature sensor
• high-speed I2C serial interface (400KHZ)
• Power supply needs: 3.3V/5V
• Fast response and High sensitivity
• Simple drive circuit
• Stable and long life

Connecting method:

• GND-GND  VCC-5V  SDA-A4  SCL-A5